How Much Thermal Paste Should You Apply to Your CPU?

When building a PC, it is imperative to add thermal paste properly. You want to know how much you need to use, how long it takes for the paste to dry, and what your CPU is likely to take.

Thermal paste is an important part of building a computer. Without it, heat would build up inside the case and cause the temperature inside the PC to rise. To avoid this from happening, many choose not to use thermal paste at all and instead opt for air cooling or lower powered CPU chips. Here are some tips about how much thermal cpu paste you should apply for your particular case.

What is thermal paste?

Thermal paste is an adhesive compound used to transfer heat from one surface to another over a longer distance. In the case of building a computer, thermal paste is applied between the CPU and the metal or plastic surface of the case.

The paste is used to improve cooling efficiency by transferring heat away from the CPU and into a larger area where it can be dissipated. It also makes cleaning easier because it reduces dust build-up on the chip itself.

One should apply thermal paste in two layers: an even layer on top of another layer already applied. A small amount of paste goes a long way and can work for many applications if you know what kind of surface you’re working with.

If you have any questions about how to use thermal paste, consult your motherboard’s manual for specific instructions.

How to properly use thermal paste

First, you’ll need to decide what type of paste you want to use and how much. There are many different types of thermal paste, and a lot of them come in pre-made blocks that can be applied with just a dab. You’ll want to choose the right type for your particular case.

Next, it is important that you apply the thermal paste only where the CPU will be touching the heat sink. This includes the bottom side of the heat sink plus any other surfaces that might have contact with your CPU.

Finally, allow the thermal paste to dry or cure for at least 30 minutes before putting your PC back together. This is necessary not only to prevent further heat dissipation but also to make sure all the paste is spread evenly across all surfaces that should be coated with it.

How long does the paste take to dry?

It will take about 15 minutes for the paste to dry. You’ll want to make sure that you apply the paste evenly and in a thin layer so the heat can effectively conduct through it.

If your PC case is active, you’ll want to wait for at least 30 minutes before turning it on. This will give the paste enough time to dry. Once you’re ready, you can power your PC on as usual.

What CPU chips should I use with my case?

Choosing the appropriate case for your CPU depends on whether you are using a cooler or air cooling. With air cooling, you will need to use less paste, but with a cooler, it would be best to use about 1/4 inch of paste.

If your case is smaller than 11 inches long, then you should place approximately 0.5-1 mm of thermal paste in order to create a better barrier between the CPU chip and the heat sink.

If your case is larger than 11 inches long, then you should place approximately 2-3 mm of thermal paste in order to create a better barrier between the CPU chip and the heat sink.

If your case is greater than 12 inches long and less than 16 inches wide, then you should apply about 3-4 mm of thermal paste in order to create a better barrier between the CPU chip and the heat sink.

If your case is greater than 16 inches wide and less than 22 inches long, then you should apply about 4-6 mm of thermal paste in order to create a better barrier between the CPU chip and the heat sink.

Conclusion

Using thermal paste is a key step in the process of overclocking your PC. It is a substance that is applied to the CPU and GPU to transfer heat away from them and into the case.

Thermal paste can make your PC run cooler, but it is also important to use the right paste for your PC, CPU, case and motherboard. If you want to learn more about this, you should check out this article.

Recommended: Quickly Repair Damaged Company Files With Quickbooks File Doctor

Total Views: 159 ,
By Michael Caine

Leave a Reply

Your email address will not be published. Required fields are marked *

Related Posts